[ Chinese wardrobe network ] Usually after we buy the solid wood wardrobe , because the goods are to be transported, the merchants will disassemble the furniture for transportation. It is difficult to assemble the wooden wardrobe. The introduction of the Chinese wardrobe net wood wardrobe assembly teaches you to correctly install the wooden wardrobe.
General sellers will send the installation instructions of the wooden wardrobe together with the wardrobe parts, so before installing the wooden wardrobe, you must clearly understand the instructions. Then follow the instructions on the instructions to make the correct installation. The common installation is divided into the following steps:
1. The general wooden wardrobe assembly is first installed from the end of the wall. The first step is to lay the wide side panel on the ground to see if the hole spacing on the wooden board matches the position on the drawing sheet, and then install it. Single three-in-one single link. Then, the solid layer is nailed to the cork and fixed on the wide side plate, the top handle has a large handle hole facing upward, the other solid layers are facing downward, and the foot line large handle hole faces inward.
2, to nail the backboard, in order to do this in order to better fix the wardrobe and facilitate our operation. First put the assembled whole wardrobe side on our pre-paved cloth, and flatten the side panels of the wooden wardrobe into the same plane. Measure with a ruler and measure the diagonal dimensions of our cabinets to equal. Then install the first backboard from the wide side panel. Here we should note that if there is a fixed layer of nails in the middle of our wooden wardrobe, it is best to draw the center line of the fixed layer with a pencil. Nail the nails. Ok, now we should install the L frame, first use the side plate of the L frame on a parallel line above the corresponding side plate, then move up the 9mm to draw the center line of the three-in-one rubber, with the L frame The top shift draws a parallel line on the corresponding bottom plate, and draws the center line of three rubber particles in the flat line. The hole was drilled with a 10 mm drill bit and the hole depth was 10-20 mm. Install a single pole. After the L frame is installed, nails are fixed on the back plate. This way our wooden wardrobe installation is basically formed.
Guangzhou Jie Lin international trade Co., LTD , https://www.jinlintrade.com