The shower is a must-have item for the shower. It not only gives people a pleasant shower but also embellishes the bathroom. When you buy a shower back, how do home users install it? Please follow Xiaobian to see the following steps.
Installation tools: shower set one set; large wrenches, pliers, allen wrenches, drills, screwdrivers.
Installation steps and methods:
1. After the two elbow joints are wrapped around the raw material band, tighten the spanners on the outlet fittings in the two mounting holes on the wall with a spanner wrench. After tightening, ensure that the center distance between the two elbow joints is 150 mm.
2. Put the two decorative covers on the elbow joints;
3. Insert the mounting washer into the elbow connector and use a wrench to tighten the mounting nut on the elbow connector to secure the faucet to the wall.
4. Drill three holes with a diameter of 6mm and a depth of 35mm at a position approximately “H†from the tap outlet connector.
5. Into the expansion hole in the mounting hole, respectively, using a self-tapping screw to fix the wall to the wall. Note: Wall stand must be on the same center line as faucet outlet fitting.
6. Wrap the faucet with a cloth before drilling to avoid the faucet being soiled and bumped.
7. The height "H" must be determined according to the actual product when it is actually installed.
8. Insert the sealing ring into the lower end of the switching valve.
9. Screw the lower end of the switching valve and the upper end of the tap through the thread.
10. Wrap the faucet with a cloth before drilling to prevent the faucet from being contaminated and bumped. Note: When using a wrench, tighten the plated surface carefully.
11. Screw one end of the shower rod and one end of the switch valve through the threads (the end of the column shower rod must have a seal).
12, then the decorative cover into the other end of the shower rod, and then insert that end into the wall seat, respectively, in the end with three set screws to lock, and finally push the decorative cover to the wall;
13. After the installation, open the water inlet switch to thoroughly flush the pipe.
14. Connect the nut end of the shower hose to the connector on the back of the switch valve body. Connect the nut to one end of the hand shower and insert it into the shower seat. (Note: The shower hose must have washers on both ends.
15. Screw the top spray onto the shower rod.
<\p><\div>
Beauty And Personal Care Products
PLLA filler, as injectable poly-l-lactic acid is used to create structure, framework, and volume to the face. PLLA is known as a bio-stimulatory Dermal Filler, this means it stimulates your own skin to produce new collagen. Over time your skin breaks down PLLA into water and carbon dioxide.
As we age, the fat, muscles, bone, and skin in our face begins to thin. This loss of volume leads to either a sunken or sagging appearance of the face. Injectable poly-l-lactic acid is used to create structure, framework, and volume to the face.
Body Care,Eyes Care,Face Care,Hands And Feet Care
Rimless Industry Co.,Ltd. , https://www.rebornplla.com